DEV Community

#machining

Posts

đź‘‹ Sign in for the ability to sort posts by relevant, latest, or top.
Why Seal Surfaces Leak While the Ra Number Looks Fine

Why Seal Surfaces Leak While the Ra Number Looks Fine

Comments
3 min read
Detect 5-Axis Rotary Reversals Before They Become Surface Marks

Detect 5-Axis Rotary Reversals Before They Become Surface Marks

Comments
4 min read
The Ultimate Guide to 304 Stainless Steel: Food Safety, Rust, and Daily Uses_evefab

The Ultimate Guide to 304 Stainless Steel: Food Safety, Rust, and Daily Uses_evefab

Comments
3 min read
Thread Milling vs Tapping vs Rolling: What Actually Changes in the Quote

Thread Milling vs Tapping vs Rolling: What Actually Changes in the Quote

Comments
4 min read
304 vs 316 vs 17-4 PH: what actually changes in a stainless quote

304 vs 316 vs 17-4 PH: what actually changes in a stainless quote

Comments 1
4 min read
0.005 mm: When a Tight Tolerance Actually Matters, and When ISO 2768-m Is Enough

0.005 mm: When a Tight Tolerance Actually Matters, and When ISO 2768-m Is Enough

Comments
3 min read
A 0.5 mm Wall Doesn't Move While You Cut It: Notes From Filming a 4-Axis Aluminum Job

A 0.5 mm Wall Doesn't Move While You Cut It: Notes From Filming a 4-Axis Aluminum Job

Comments
4 min read
What Your 40 / 1,000 / 10,000-Piece Order Actually Tests in a Chinese 5-Axis Shop

What Your 40 / 1,000 / 10,000-Piece Order Actually Tests in a Chinese 5-Axis Shop

Comments 1
3 min read
CNC Aluminum Parts: What Actually Changes Between 200 Pieces and 10,000

CNC Aluminum Parts: What Actually Changes Between 200 Pieces and 10,000

Comments 1
3 min read
Guide Bushings Explained: Why Swiss-Type Lathes Hold Tolerances on Long, Thin Parts

Guide Bushings Explained: Why Swiss-Type Lathes Hold Tolerances on Long, Thin Parts

Comments 1
5 min read
CNC Machining Time Explained: Why Your Actual Cycle Time Is Longer Than the Calculation

CNC Machining Time Explained: Why Your Actual Cycle Time Is Longer Than the Calculation

Comments
14 min read
Material Removal Rate (MRR) Explained: Why Faster Feed Doesn't Always Mean Higher Productivity

Material Removal Rate (MRR) Explained: Why Faster Feed Doesn't Always Mean Higher Productivity

Comments
14 min read
What paperwork actually follows a machined medical part out of a Chinese shop

What paperwork actually follows a machined medical part out of a Chinese shop

Comments
6 min read
CNC Feed Rate Explained: Why F1000 Doesn't Always Mean the Same Thing

CNC Feed Rate Explained: Why F1000 Doesn't Always Mean the Same Thing

Comments 1
12 min read
Feed per Tooth (fz) Explained: The CNC Parameter Behind Feed Rate and Chip Load

Feed per Tooth (fz) Explained: The CNC Parameter Behind Feed Rate and Chip Load

Comments
12 min read
đź‘‹ Sign in for the ability to sort posts by relevant, latest, or top.